EK600
The ratio of the plastic moment to the yield moment is known as theshape factor since it depends on the shape of the cross section.
EK573
Although steel tension members can sustain loads up to the ultimate load without failure, the elongation of the members at this load would be nearly 10-15% of the original length […]
EK165
When shear and bearing bolts in clearance holes are used in an in-plane force joint, there is an initial slip when the shear is first applied to the joint as […]
EK126
The yield zone is developed over a certain length, normally called the plastic hinge length, depending on the loading, boundary conditions, and geometry of the section. Plastic hinges are developed […]
EK71
The first yield criterion for a combined state of stress for metals was that proposed by Tresca who suggested that yielding would occur when the maximum shearing stress at a […]
EK69
For most materials after the initial yield point has been reached,the stress-strain curve continues to rise although the slope becomes progressively less, until the slope falls to zero as failure […]
EK49
Elastic buckling is a state of lateral instability that occurs while the material is stressed below the yield point.